O2k configuration

From Bioblast
Jump to navigation Jump to search

Header ecosystem 2020.jpg

OROBOROS support
        O2k-Manual         O2k-Videosupport         O2k-Procedures         MitoPedia: O2k hardware         MitoPedia: DatLab         MitoPedia: SUIT         MitoPedia: O2k-Open Support        

O2k configuration

Template NextGen-O2k.jpg
O2k-Open Support

MitoPedia O2k and high-resolution respirometry: O2k-Open Support 


In O2k configuration, channels (amperometric and potentiometric) can be switched on/off by selecting the according tick box. The Power-O2k number (P1, P2, ..) and numbers for O2 sensors, Amp sensors, pX electrodes and pX reference electrodes are entered or edited here. With the O2k-FluoRespirometer (O2k-Series H and higher), the serial numbers of the Smart Fluo-Sensors are shown automatically under [Amperometric, Amp]. The O2k configuration window pops up when DatLab starts and "Connect to O2k" is pressed for the first time. It is also accessible from the menu "Oroboros O2k" and from within the O2k control and Mark statistics windows.


MitoPedia O2k and high-resolution respirometry: DatLab 

O2k-Series H and higher: Fluorescence sensors serial numbers

Communicated by Ondrej Capek 2017-07-11.
Problem (special case):
(i) O2k-Series H or higher Main-Unit is switched on with fluorescence sensors already connected
(ii) DatLab is started afterwards and "Connect to O2k" clicked - the O2k configuration window is opened
(iii) Problem: DatLab does not show the corresponding serial numbers of the fluorescence sensors under "Amperometric, Amp"
(i) Confirm the O2k configuration window with "OK" or "Cancel" - the O2k control window is opened
(ii) Open the "O2k configuration" window again (this can be done directly in the O2k control window by a click on "O2k configuration")
(iii) Now the correct fluorescence sensor serial numbers are shown automatically